P6 - 75152 Rev. C 0416
Installation Instructions - PowerBoard
®
© 2016 Bestop, Inc.
Page 6
Route the short leg of the Wiring Harness
(labeled “Side 1”) down the firewall and
along the frame rail of the vehicle, on the
same side as the battery. Keep the harness
away from heat and exhaust system. Secure
the harness to the frame using the #460.99
7” cable ties.
Route the long leg of the Wiring Harness
(labeled “Side 2”) across the firewall and
down the opposite side of the vehicle from
the battery location. Secure the harness to
the firewall and frame using the #460.99
7” cable ties.
Step 2
Connect the Wiring Harness to the
Controller. Make sure that the locating
tabs are fully engaged.
Secure the Controller to the vehicle
wiring harness with two 11” Cable
Ties.
Step 1
11”
Side 1
Short Leg
Wiring
Harness
Side 2
Long Leg
7” Cable ties
as needed
along firewall
Controller
Part #496.11
Qty. 1
Wiring Harness
Part # 523.19
Qty. 1
Hardware
11” Cable Tie
Part #470.02
Qty. 2
7” Cable Tie
Part #460.99
Qty. 25
Controller
Part #496.11
Qty. 1
Wiring Harness
Part # 523.19
Qty. 1
Step 1
Step 2
Section 3
Install Controller & Wiring Harness
