P13 - 75152 Rev. C 0416
Installation Instructions - PowerBoard
®
© 2016 Bestop, Inc.
Page 13
Section 10
Replace Wire Harness Fuse; Check Deployment & Tighten All Fasteners
Step 1
Step 2
Step 2
Step 1
Tighten fasteners according to
instructions on Page 4 of this guide.
WARNING
Fuse
Never force the PowerBoard
®
up
or down. Always use the motors
to cycle the boards.
Never step on the PowerBoard
®
until it is fully deployed.
WARNING
Open and shut each door to make sure that the
PowerBoards
®
deploy and retract properly.
Note that there is a slight delay on the board
deployment so make sure that the board is fully
deployed before stepping onto it.
There is also a 3-4 second delay in board retraction
after a door is closed. This gives you time to open a
door again without cycling the board again.
Close the doors to retract the linkages.
Refer to Page 4 of this guide for instructions
on the order of tightening fasteners and torque
specifications.
Make sure all doors are closed.
Re-install the fuse in the PowerBoard
®
Wire
Harness. This fuse was removed at the
beginning of the installation process.
Keep hands clear of the linkages.
Withing approximately 30 seconds the
boards will retract.
