1 Slide a Torsion Bar Collar #517.95 onto each
end of a Torsion Bar - #517.93 and #517.94.
2 Place the Torsion Bar and collars into position
on the ends of the shafts on each linkage. Make
sure that the Torsion Bar is marked with a “D” for
Driver side, and a “P” for Passenger side.
3 Slide the collars over both the Torsion Bar and
the linkage shafts, aligning the holes in the collars
with the holes in the Torsion Bar and linkage shafts.
4 Assemble one #M6-1.0x30 Socket Cap Screw,
two #M6 Flat Washers, and one #M6 Nylon Lock
Nut through the hole in each collar. Tighten the
screw before tightening the Nylon Lock Nut.
P11 - 75152 Rev. C 0416
Installation Instructions - PowerBoard
®
© 2016 Bestop, Inc.
Page 11
Section 8
Attach Motor Linkages and Torsion Bars
Step 1
2
1
Motor
Step 1
Step 2
1 With the Motor Linkage positioned as shown
above, install two #M8-1.25x 20 Button Head Screws
with #M8 Flat Washers through the welded body
flange and into the two threaded holes
closest to the motor in the face of the Motor
Linkage. The Motor Linkage should be behind
the welded body flange.
2 Insert one #M8-1.25x25 Button Head Screw
with #M8 Flat Washer through the Motor Linkage
flange as shown, and up into the pre-existing
threaded hole in the bottom of the body pan.
Driver side shown. Repeat on passenger side.
WARNING
Only tighten screws holding
the Motor Linkage to the vehicle finger tight at
this time.
Hardware
Step 2
2
3
4
1
#M8 Flat Washer
Part #470.05
Qty. 3 per linkage
#M8-1.25x25
Button Head Screw
Part #522.95
Qty. 1 per linkage
#M8-1.25x20
Button Head Screw
Part #473.83
Qty. 2 per linkage
#M6 Flat Washer
Part #481.96
Qty. 4 per Bar
#M6 -1.0 Nylon Lock Nut
Part #490.93
Qty. 2 per Bar
#M6 -1.0x30
Socket Cap Screw
Part #523.15
Qty. 2 per Bar
