P12 - 75152 Rev. C 0416
Installation Instructions - PowerBoard
®
© 2016 Bestop, Inc.
Page 12
Section 9
Attach Boards and Lights
Clean the mounting surfaces with a 50/50 mix of
isopropyl alcohol and water.
Remove the adhesive liner from the bottom of the
light and firmly press it into the recessed area on
the motor linkage.
Plug the pigtail from the light into the connector on
the wiring harness with the orange and black wires.
Secure loose wires with the 7” Cable Ties as
necessary.
Driver side shown. Repeat on passenger side of
the vehicle.
Attach the PowerBoard
®
to the linkages using two
#M6-1.0x20 Socket Cap Screws per linkage.
Only tighten the screws
holding the Motor Linkages to the vehicle finger-
tight at this time.
WARNING
Step 1
Step 1
Step 2
Hardware
Step 2
#M6-1.0 x 20
Socket Cap Screw
Part # 470.00
Qty. 2 per Linkage
Light
Part #470.15
Qty. 2 per side
7” Cable Tie
Part #460.99
Black
Orange
