- 13 -
If you forget the number combination, proceed as follows to unlock the camera
and to reset it to its factory default settings:
Keep the
RIGHT BUTTON pressed while moving the operating mode
selector switch to the SET position. Keep the button pressed untill you see
the boot picture.
After about 5 seconds the camera will switch on and can now be used
without a password.
Format memory card
Formatting the memory card will permanently delete all data on it. Before you
use a new memory card in the camera or a card that has previously been used
in another device, you should first format the memory card. Select "Yes" with
the OK button and confirm the following prompt with the OK button. The
formatting process starts.
While the card is being formatted, the message "Please wait" appears.
CAUTION
►
Ensure that the memory card does not still contain any files that you need!
Default settings
If you select "Yes" the menu item and then slide the select bar in the following
prompt to "OK" using the
buttons and then press the OK button, all
previously made camera settings including any password will be deleted and the
factory settings will be restored.
Activating live mode
The normal operating mode of the camera is so-called live mode.
In this mode, recordings are triggered via the motion sensors.To set live mode,
slide the operating mode selector switch to the "ON" position,and at this time,
the display screen will be Turned Off to save batteries.After a few seconds the
red LED of the motion display will go off . Then the camera will start to operate
independently and will go into standby mode. As soon as any wild animals or
similar enter the detection range of the central sensor zone, the
camera will start capturing photos and/or videos (depending on the
configuration).
If wild animals enter the detection range of the side motion sensors ,these will
detect the motion and activate the camera. If the wild animals continue to move
in front of the front motion sensor, the camera will carry on taking photos/videos.
When the wild animals leave the detection range of the side motion sensors , the
camera switches off and goes back into standby mode.
Night exposures
During night exposures the infrared LEDs on the front of the camera provide the