Installation Instructions for Wi-Q Technology™ EXQ Exit Hardware Trim
BEST
a Product Group of dormakaba USA Inc.
6
Preparing the door
3
Position trim template and mark drill
points
1
For new installations
a Cut the applicable template
along the dashed lines.
b Align the horizontal and vertical centerlines
marked on the template with the centerlines
marked on the
OUTSIDE
of the door (from step 1).
See Figure 8.
For retrofit installations
Align the mounting holes for the escutcheon and
lock stile case shown on the template with the
mounting holes already present in the door.
Note:
The outside escutcheon is mounted using the
four lock stile case mounting holes (‘A’ holes); these
holes must be 7/16
″
in diameter and drilled com-
pletely through the door.
2 Tape the template to the
OUTSIDE
of the door in the
properly aligned position.
3 Center punch the necessary drill points. Refer to the
instructions on the template and the figures of the
previous step.
4
Mortise for mortise case and faceplate
(mortise exit devices only)
Note:
If retrofitting the EXQ Exit Hardware Trim to an
existing exit hardware installation, skip this task.
Mortise the edge of the door for the mortise case and
faceplate; follow the instructions provided by the exit
hardware manufacturer.
Figure 8
Positioning the trim template,
Q08 LHRB shown
Trim template
Horizontal centerline
of lock
Vertical centerline
of lock
Outside of door