Installation Instructions for Wi-Q Technology™ EXQ Exit Hardware Trim
BEST
a Product Group of dormakaba USA Inc.
10
Installing the exit hardware and trim
For Precision 2200, 2700 and 2800 devices
4 Re-route the sensor harness around the cylinder hole
and around the escutcheon boss, then out through the
alternate wire-routing hole as shown in Figure 13.
5 Reattach the backplate ensuring that the springs are
properly seated and wires are not pinched.
6 Reapply the gasket.
For Precision 2300 and Sargent 8800 devices
4 Re-route the sensor harness toward the top of the
escutcheon to the same area as the battery cable,
antenna cable and relay shunts. See Figure 14.
5 Reattach the backplate ensuring that the springs are
properly seated and wires are not pinched.
6 Reapply the gasket.
For Von Duprin Rim devices with RQE
4 Re-route the sensor harness around the cylinder hole
and around the escutcheon boss, then out through
one of the alternate wire-routing holes (based on
handing) as shown in Figure 15.
5 Reattach the backplate ensuring that the springs are
properly seated and wires are not pinched.
6 Reapply the gasket.
Figure 13 Re-routing the sensor harness for Precision
2200, 2700 and 2800 exit devices
Route
sensor
harness
here
Backplate
Sensor
harness
Route
sensor
harness
here
Backplate
Sensor
harness
Figure 14 Re-routing the sensor harness for Precision 2300
and Sargent 8800 exit devices
Route
sensor
harness
here for
LHRB
Backplate
Sensor
harness
Figure 15 Re-routing the sensor harness for Von Duprin
with RQE
Route
sensor
harness
here for
RHRB