Installation Instructions for Wi-Q Technology™ EXQ Exit Hardware Trim
BEST
a Product Group of dormakaba USA Inc.
17
Installation Instructions for Wi-Q Technology™ EXQ Exit Hardware Trim
Completing the installation
17
Install battery bracket on door
1 Position the battery bracket on the inside of the door
as shown in Figure 28.
Note:
If installing with a surface rod exit device, the bat-
tery bracket is mounted over the upper rod.
2 Secure the battery bracket to the door using two of the
mounting screws provided.
Note:
For doors less than 2
″
in thickness, use the
1 1/4
″
screws. For doors 2
″
or greater, use the
1 3/4
″
screws.
Caution:
When routing the wire harness, make
sure the wires are not routed across any sharp
edges or over any surface that could damage their
sleeving or wire insulation. Keep away from any
moving parts.
3 Tape all wires to the bracket using the tape provided.
Note:
For Precision 2300, Sargent 8800, or any Von
Duprin exit device without RQE, sensor harness and door
position switch wires will also be run into this area of the
battery bracket.
Figure 28 Installing the battery bracket on the door
Mounting
screws
Inside of door
Battery
bracket
Antenna
wire
Battery
connector
Relay shunt
wires
