Installation Instructions for Wi-Q Technology™ EXQ Exit Hardware Trim
BEST
a Product Group of dormakaba USA Inc.
18
Completing the installation
18
Install battery pack in bracket
1 Connect the battery pack to the battery connector on
the wire harness as shown in Figure 29.
Caution:
When connecting the battery pack,
make sure:
—
there are no loose wire connections where the
wires are inserted into the connectors
—
the connectors are firmly mated.
2 Place the battery pack in the holder inside the battery
bracket and dress the wire harness inside the bracket.
Caution:
The battery pack fit will be snug. Make
sure you do not damage the sleeving on the bat-
tery pack. Doing so may cause the batteries to
drain.
3
If installing with a surface vertical rod device
,
dress the wire harness inside the bracket to the left of
the rod so that the harness will not interfere with the
movement of the rods.
We recommend that you loosely coil the harness and
use a cable tie to secure the coil. To avoid damaging
the harness, do not put any sharp bends in it or flex it
close to the connectors.
Caution:
Failure to dress the wire harness away
from the rod could damage the wire harness,
causing the lock’s electronics to not work prop-
erly.
Figure 29 Connecting the battery pack
Battery pack
Inside of door
Battery bracket
Antenna wire
Relay shunt
wires