DALIK
- Gateways
Programming manual
v1.4.3
www.besknx.c
z
27
Limit violation: Yes/no. Indicates if there has been any limit violation.
Scene active: Yes/no. Indicates if any scene has been executed or not.
Reset values: Yes/no. Indicates if the DALI ballast has been reset.
Address missing: Yes/no. Indicates if the DALI ballast has missed or not the address.
Power on level: Yes/no. Indicates if the DALI ballast brightness value is at power on level or not.
Parameters: In this section are shown the current DALI parameters that have been read. They can be edited
by clicking on them and using the scroll bar on the right. Take into account that the behaviour of some
parameters depends on the DALI ballast and maybe cannot be edited through the whole range.
Actual level: 0-255. It is the current brightness level of the light.
Max level: 0-255. It is the maximum brightness level that the ballast can reach.
Min level: 0-255. It is the minimum brightness level that the ballast can reach.
Power on level: 0-255. It is the brightness level that it is set after a main power supply failure.
System failure level: 0-255. It is the brightness level that it is set when there is a DALI cable failure.
Fade time: 0-15. It is the time that the ballast takes to dim from any value to a new brightness value.
Fade rate: 0-15. It is the rate that the ballast takes to dim from any value to a new brightness value.
The individual value of each light is memorized (every 10 seconds). When there is a power failure, the last value
is sent automatically (after 3 seconds) when the gateway recovers its KNX power supply. If the light is not included
in the project (gateway memory) it will not be sent. If there is a power supply failure of the DALI ballast (but not in
the gateway), the value set after it is the individual power on level parameter.
Check configuration: In this section there are several on-line tools that give the programmer the possibility
of testing functionalities for individual DALI light localization and check.
Do click on close to go back to the main view of the plug-in.