31
Preparation
Tips :
- Take off the zig zag foot and attach the
buttonhole foot.
- Measure diameter and thickness of button
and add 3 mm (1/8") for bar tacks; mark
buttonhole size on fabric. (a)
- Place fabric under the foot, so that mark on
the buttonhole foot lines up with the marking
on the fabric. Lower the foot, so that the
center line of the fabric buttonhole comes to
the center of the foot hole. (b)
Adjust the stitch length dial in the "
" range to
set stitch density.
1. Select "
" on stitch selector dial and sew a
few bar tacks.
2. Select "
" and sew the left side of the
buttonhole.
3. Select the same pattern as in "
" and sew
the back bar tack.
4. Select "
" and sew the right side of the
buttonhole.
5. Use seam ripper and cut buttonhole open
from both ends towards the middle.
- Slightly reduce upper thread tension to
produce better results.
- Use a stabilizer for fine or stretchy fabrics.
Note:
Please Note:
density varies according to the fabric.
Always sew a test buttonhole.
No "S1" marking is shown on the stitch length
dial by model sew&go 1.
sew&go 1 / 3
Sew 4-step buttonholes
Stitch length dial
1
2
3
4
5
For 2-dial model
(a)
(b)
3
m
m
