Berner BGI40, Operating Instructions Manual

Page: 14 / 34

side 13 from 34 08.11.2014
Ver. 2.9 © Berner cooking systems 2014
service
Cooking process
The device is immediately ready for operation. The power indicator light lights up and the
digital display shows the desired, reached temperature or any error messages to. The
temperature is continuously selected bydeerenofing the temperaturecontroller or with the
sensor keypad.
Position MIN > 70°C minimum temperature
Position MAX> 250°C maximum temperature
Due to the following circumstances, the cook must be more attentive than when frying with
conventional cooking systems. The frying plate is in operating temperature in a short time and
can therefore be set into standby or deactivated when not in use.
comfort
The inductiongerät transmits energy to the heating zone(n)onlyif the temperature falls below
the selected value. By switching off with the rotary knob, the heatingprocess is stopped.
However, the device remains ready for operation (standby), only the pull-out of the power plug
or the power switch is switched off, making the device powerless.
Software Version
Starting up the generator
second explanation
1 8. (Test of segments)
2 F or P (operation F sequence or P ulse)
3 2. (Software version first digit)
4 1 (Software version second digit)
5 9 (Software version third digit)
Meaning Decimal Point:
AN = Operation
1 sec. pulse = limitation due to too high heat sink temperature
1/2 sec. pulse = limitation due to excessively high coils/pan temperature
1/4 sec pulse = power limit
1/10 sec. pulse = power limitation with not optimal Material
attention! Cookware must not be placed on the frying surface. Do not place hot pots or
pans on the control panel, displays or hobs. Ignoring this notice will damage the pots and
equipment. Effect of ignoring: Pots are welded together. Defect of the displays or control
panels.