Berner BGI40, Operating Instructions Manual

Page: 10 / 34

side 9 from 34 08.11.2014
Ver. 2.9 © Berner cooking systems 2014
commissioning
assembly
The inductiongeräte are equipped with a power cable. They must be connected to a wall socket
or junction box. The electrical installations must be carried out by approved installers in
compliance with specific national and local regulations. The installers are responsible for the
correct design and installation in accordance with the safety regulations. The warning and type
plates must be strictly followed.
Check and make sure that the voltage of the mains current and the device (type plate) match.
When installing this appliance in the immediate vicinity of a wall, partition walls, kitchen
furniture, decorative cladding, etc., it is recommended that these are not made of combustible
material; otherwise, they must be clad in suitable non-combustible, thermally insulating
material, and the fire protection regulations must be observed with the most care!
The inductiongerät must be in a clean, straight surface (table, combination, etc.) ebuilt up and
stand by its final destination. It must be installed in such a way that it cannot be moved. The
"installation requirements" must be met.
Remove all items from the heating zone(s). Check that the heating zone(s) is neither split nor
broken. If the heating zone is split or broken, immediately turn off the device and disconnect
the power plug.
Turn the main switch to the OFF position (0) before
Connect inductiongerät to the power grid.