Bernecker + Rainer 5PC820.SX01-00, User Manual

Page: 206 / 318

206
Software • B&R Automation Device Interface (ADI) - Control Center
Automation PC 820 User's Manual V 1.20
7.3 SDL equalizer setting
1) Start the Control Center in the Control Panel .
2) Then select the Display tab.
3) Click on Settings . This opens the following dialog box:
You can change the display's SDL equalizer settings in this dialog box. The equalizer is
integrated in the Automation Panel and adapts the DVI signal to various cable lengths. The
equalizer value is automatically calculated based on the cable length: You may set a different
equalizer value in order to obtain the best possible display quality (e.g. with low-quality cables or
poor DVI signal quality).
The value is optimally defined for the cable length when using the "Automatic setting".
The equalizer value can only be changed if the function is supported by Automation Panel 900
(starting with Panel Firmware version 1.04 or higher).
Information:
The ADI driver and B&R control center are already included in the Windows XP
Embedded and Windows Embedded Standard 2009 operating system.
If a more current ADI driver version exists (see the B&R homepage download area),
it can be installed later. A potentially activated "Enhanced Write Filter (EWF)" must
be taken into consideration when installing.
Figure 88: ADI Control Center - SDL equalizer settings