Bernecker + Rainer 5PC820.SX01-00, User Manual

Page: 101 / 318

Commissioning • Connection examples
Section 3
Com
m
is
sio
ning
101 Automation PC 820 User's Manual V 1.20
3.6 Four Automation Panel 900 units via SDL
One Automation Panel 900 is connected to the integrated SDL interface via an SDL cable. Up
to three other Automation Panels of the same type are connected to this Automation Panel and
operated via SDL. All four panels show the same content (Display Clone).
USB is supported up to a maximum distance (SDL segment 1 + SDL segment 2) of 30 m on the
first two panels (front and back side). From a distance of 30 m and longer, USB is only available
for the first panel (front and back side). USB devices can only be connected directly to the
Automation Panel (without a hub).
3.6.1 Basic system requirements
The following table displays the possible combinations for the APC820 system unit with CPU
board to implement the configuration shown in the figure above. If the maximum resolution is
limited when making the combination then it is also shown in the following table (e.g. for
connecting a non-B&R Automation Panel 900 device).
Figure 35: Configuration - Four Automation Panel 900 units via SDL
CPU board with system unit Restriction
Resolution
5PC820.SX01-00 5PC820.SX01-01
5PC800.B945-00 / -10
✓ ✓
Max. UXGA
5PC800.B945-01 / -11
✓ ✓
Max. UXGA
5PC800.B945-02 / -12
✓ ✓
Max. UXGA
5PC800.B945-03 / -13
✓ ✓
Max. UXGA
5PC800.B945-04 / -14
✓ ✓
Max. UXGA
Table 72: Possible combinations of system unit and CPU board
✓
Automation PC 820
SDL segment 1
max. 40 m
Link: 5DLSDL.1000-01
USB
not possible
Link: 5DLSDL.1000-01
USB OK
0
2
SDVO-B
x
Internal APC panel number
Link: 5DLSDL.1000-01
1
Link: 5DLSDL.1000-00
3
SDL segment 2
max. 40 m
SDL segment 3
max.
40 m
SDL segment 4
max. 40 m
USB
not possible
USB
possible
independent of segment length
depends on segment length
✓ ✓
✓
Monitor / Panel
connection