Use JB weld to glue the ends into the boom supports. Ensure that the ends are
parallel to each other. Secure one end to the bottom rear of the lower frames
with 2ea 3X12 SHCS, 3m washers, and 3m Locknuts.
Secure the rear of the boom supports with a 3X35 SHCS, 2 ea 3m washers, and a
3m locknut, but don’t tighten the bolt just yet. Install the horizontal fin (if not
already installed) onto the clamp with 2 ea 3X8 SHCS. Use CA (superglue) as a
loctite on these 2 bolts.