Make slight adjustments to the length of the rod so that the ball on the
outside of the aileron bellcrank lines up EXACTLY over the bolt going to the
elevator yoke axle. This is done with power ON to ensure the servo is
centered…
Then use the
40mm
long rod to make the linkage from the aileron bellcrank to
the swashplate
57mm
long center to center or
64mm
long end to end.
Elevator servo to “X” arm linkage is made from the
130mm
long rod and is
148mm
long center to center or
155mm
long end to end. Note the orientation
of the “X” arm with the LONG leg straight up. With power on, adjust the rods
as needed to get this leg to point straight up.