20
Bentone
165 305 01
5. Burner servicing
5.1 Servicing the combustion device
Removal and installation
1. Switch off the mains power..
2. Remove the nuts (H) and pull the burner body out of the guides from
the burner fl ange.
3. Remove the brake plate from the oil pipe and clean the brake plate.
4. Unscrew the nozzle/nozzles.
5. Fit the nozzles
6. Install the brake plate. (See technical data)
7. Check the ignition electrodes. ( See technical data)
8. If necessary, replace the ignition electrodes.
9. Fit the burner body and the burner fl ange together and secure with the
nut (H).
10. Open the boiler/spectacle fl ange to access the burner pipe.
11. Remove and clean the burner pipe.
12. Install the burner pipe, make sure you install the drainage hole (not on
all burner pipes) facing downwards so that any spilled oil can drain out.
13. Close the boiler / spectacle fl ange.
14. Turn on the mains power.
15. Check combustion*.
!
Use caution when
operating the bur-
ner, surfaces may
be hot.
!
When soiled,
always replace
nozzles with new
nozzles.
Note:
*
When servicing/replacing components that affect combustion, an
analysis and soot test must be carried out on the installation
!
If the burner is directly connected, ensure that all
components on the burner are without power.
H
H
Summary of Contents for B 80-3R
Page 29: ...29 Bentone 165 305 04 7 Electric equipment 7 1 Safety system...
Page 54: ......
Page 55: ......
Page 56: ...Enertech AB P O Box 309 SE 341 26 Ljungby www bentone se www bentone com...