Bentel J408, Installation Manual

Page: 45 / 64

PROGRAMMING FROM A PC
You can program this system from the Control panel or
from a computer, using the J400 application.
This section describes how to program the system from
a computer. If you intend programming the system from
the Control panel refer to the “PROGRAMMING FROM
THE PANEL” section.
Enrolling: Expander Modules
The Expander Modules page will allow you to enrol
Expander Modules, as follows.
ü Enrol the Expander Modules (if installed).
A tick ( þ ) indicates that the respective device is part of
the system.
Description This 16 character field will allow you to as-
sign a label to the Expander Module. For example, if the
Expander Module monitors a particular part of the pre-
mises, it may be useful to assign the name of the area
concerned. The assigned label will identify the Expan-
der Module in all the operations it is involved in.
Enrolling: Extinguishment Modules
The Extinguishment Modules page will allow you to
enrol and set up Extinguishment Modules, as follows.
ü Enrol the Extinguishment Modules (if installed).
A tick ( þ ) indicates that the respective device is part of
the system.
Description This 16 character field will allow you to as-
sign a label to the Extinguishment Module. For exam-
ple, if the Extinguishment Module is intended for fire ex-
tinction in a particular part of the premises, it may be
useful to assign the name of the area concerned. The
assigned label will identify the Extinguishment Module
in all the operations it is involved in.
Setting up an Extinguishment Module:
— select the Extinguishment Module on the left-hand
side of the page, then program the respective parame-
ters on the right-hand side of the page, as follows.
PROGRAMMING FROM A PC 37
Figure 23 Extinguishment Modules page