Bentel Security ABSOLUTA ABS104M50, User Manual

Page: 9 / 68

Entering the Home Screen
On standby the keypad display is off or displays images
selected for the Digital Frame.
To carry out any operations you must access the key-
pad’s Home Screen, as described below.
1. Press the Home key for at least 3 seconds and go
to step 3 or touch any point on the display when it is
off or displays Digital Frame images:
2. Touch any point on the display again when the
standby status screen appears:
+
The key is for access in Installer or Level 4
mode. If you touch this key by mistake, touch it
again to display the user Login Screen.
3. Enter a valid PIN:
4. Press:
Ø
to cancel all numbers entered;
Ø
again to exit the Login Screen and go back to
step 2;
Ø
to confirm the PIN entered.
The keypad displays the Home Screen described be-
low.
1) Signals Icon This icon signals alarms, tampering,
failures or bypassed zones, in progress or memorised
(it changes based on whether the signal is in progress
or memory): touch this icon to display signals as de-
scribed in “Viewing Signals”.
2) Unread SMS Icon This icon signals the presence of
SMSs that have not been read; the number to the top
right indicates the number of SMSs to be read: touch
this icon to read them (only Master and Normal Users)
as described in “Received SMS”.
3) Event Transmission Icon This icon signals that
the control panel is transmitting the events (Alarm,
Tamper, Fault or Generic) through its communication
channels (voice calls, SMS, transmissions to the Cen-
tral Stations): touch this icon to cancel the transmission
in progress and those queuing as described in “Alarm
Status > Clear the transmission of events”.
4) Status Bar This zone can show the following mes-
sages (with decreasing priority):
Ø
System in Alarm , above a red bar, in an alarm (read
“Alarm Status” for more information);
Ø
Auto-arm in , above an orange bar, if the system is
about to be armed by the time scheduler (read
“Auto-arming” for more information).
5) Stop Alarms This icon indicates that the visual/au-
dio (sirens) signalling devices have been disabled by
the option
Stop Alarms (see “Menu (User) > Stop
Alarms” for more information) or through the jumper
SERV (ask your installer for more information).
ABSOLUTA OPERATIONS FROM TOUCH KEYPAD 9