Bentel Security ABSOLUTA ABS104M50 User Manual Download Page 35

Page: 35 / 68

Basic (Arming) Commands

You can control seven basic commands from standby
status by typing-in your PIN and pressing the respective
keys (refer to the following Table). Access to ALL com-
mands require entry a valid User PIN.

The Factory Default Master User PIN (0001 for
Grade 2 Control Panels and 00001 for Grade 3
Control Panels) must be changed for security
reasons (refer to “Change my PIN” in this
section).

Key sequence

(from standby status)

COMMAND

<PIN> OFF

Disarm

<PIN> ON

Arm

<PIN> A+ON

A Mode Arm

<PIN> B+ON

B Mode Arm

<PIN> C+ON

C Mode Arm

<PIN> D+ON

D Mode Arm

<PIN> ENTER

View Area status, if there are
no Troubles. From the View
Area

status

Trouble

screen, press

ENTER

, to ac-

cess the User menu.

Commands will affect

only

the Partitions common

to both the User PIN and Keypad concerned (com-
mon Partitions).

Invalid commands will be signalled by a buzz and the
following message:

May/26/10 13:54

Invalid PIN!

Invalid commands may be due to the User PIN Keypad
Partitions.

If you do not press a key within 30 seconds, the key-
pad will revert automatically to standby status except
during the input of the PIN. If the input is not com-
pleted the display keypad will show “ WRONG
PIN”, after one minute.

The User can

ENTER

the following commands at the

Keypad.

Arming (<PIN> ON)

This command will Arm all the common Partitions of the
User PIN and the Keypad concerned.

If a Exit Delay is sett, the keypad will signalize it on the
display and the buzzer will emit a series of beep.

Disarming (

PIN

OFF)

This command will Disarm all the common Partitions of
the User PIN and the Keypad concerned.

Disarm under Duress (PIN with Duress option en-
abled)

. This command requires entry of a

Duress PIN

The Control panel will Disarm the Partitions and will
send the programmed Alarm calls but will not signal the
outgoing calls on the Keypad (usually signalled by a
over the

icon).

DURESS

PINs are for forced disarming (disarming

under threat). The Duress PIN will disarm the sys-
tem and activate the Digital Communicator— that
will call the Central Station, and dialler—that will
send recorded voice messages to the programmed
telephone numbers.

Disarm by Patrol PIN

If a Patrol PIN (PIN with Patrol

option enabled) is used to Disarm the Partitions; the
Control panel will rearm the Partitions automatically
when the programmed Patrol Time expires.

PATROL PINs are enabled for Global arming / dis-
arming. PATROL PINs can disarm partitions tem-
porarily. Partitions disarmed by a PATROL PIN will
be rearmed automatically when the programmed
Patrol time elapses.

Multi-PIN/Key Disarming

If the installer has pro-

grammed the multi PIN/Key disarming for a Partition,
you need to enter/use the number of programmed
PINs/Keys to disarm the Partition, before the pro-
grammed time expires, as follow (read also the same
paragraph on “Key operations”).

Enter a valid PIN then press

OFF

or use a valid Key:

Required others

PINs or Keys

Press ESC or wait for the display message

Enter

, before enter another valid PIN, then press

OFF

, or use another valid Key: the display shows the

following message if no other PIN/Key is required

PANEL