BenQ SD3742, Quick Start Manual

Page: 45 / 76

Section 1: Quick Start Guide 5
Eng
lish
4. As illustrated, insert the stand neck
into the bottom of the display. Pay
attention to the direction of the
four screw holes on the stand neck
when inserting.
5. Secure the stand neck on the
display using the four supplied
long screws and a screwdriver.
6. As illustrated, attach the stand
onto the stand neck. Make the
wider side on the stand face
downward when inserting.
7. Secure the stand on the stand neck
using the remaining two supplied
short screws and a screwdriver.
Please refer to the illustration
below for the position of screw
holes on the bottom of the stand.
8. Carefully lift the display upright and check the installation. Move the
display to the position where it will be placed.
Screw holes
Make the wider side face downward
Screw holes
Note the direction of the arrow mark
If this display is wall-mounted, install
the protective bottom cover to prevent
foreign objects from entering the inside
of the display.
SD37_TW_EN_QSG.fm Page 5 Monday, June 23, 2008 9:47 AM