BenQ SD3742, Quick Start Manual

Page: 58 / 76

Section 1: Quick Start Guide 18
Eng
lish
7. Connect the power cable
1. Plug the appropriate end of the supplied power cord into the
AC-INLET
socket
on the rear of the display (as illustrated above).
2. Plug the other end into an appropriate wall power outlet, and turn on the switch
(if the power outlet is switched). The display will enter standby mode and the
power indicator will light up red.
Note:
• The supplied power cord is suitable for 110V AC power only.
• The type of power cord plug and socket illustrated may differ from the type used
in your region.
• Only use an appropriate power cord for your region. Never use a power cord
which appears damaged or frayed.
• Never change the plug type on a power cord. Be aware of total loading when
using extension cords or multiple outlet power boards.
• This display has no power switch. When installing the display, incorporate a
readily accessible disconnect device in the fixed wiring, or connect the power
cord to socket-outlet which must be provided near the display and easily
accessible. If a fault should occur during operation of the unit, operate the
disconnect device to switch the power supply off, or disconnect the power cord.
WARNING: This display has been engineered and manufactured with the highest
priority on safety, however, IMPROPER HANDLING OR USE CAN RESULT IN
POTENTIAL ELECTRICAL SHOCK OR FIRE HAZARD. Please handle this display
with care. If damaged, turn off the power and unplug the power cable from the
display. Transport the display to your nearest BenQ authorized service centre for
repair.
AC-INLET socket
Power outlet
Power cable
SD37_TW_EN.book Page 18 Thursday, June 19, 2008 3:20 PM