53
Operation (under non-Launcher source)
Controlling the projector via LAN
Wired LAN allows you to manage the projector from a computer using a web browser when the
computer and the projector are properly connected to the same local area network.
Configuring the Wired LAN Settings
If you are in a DHCP environment:
1. Take a RJ45 cable and connect one end to the LAN input jack of the projector and the other end to
the RJ45 port.
2. Go to
Advanced Menu - System > Network
>
Wired LAN
. Press
OK
. The
Wired LAN
page appears.
3. Press to select
DHCP
and press / to select
On
.
4. Please wait for around 15 - 20 seconds, and then re-enter the
Wired LAN
page.
5. The
IP Address
,
Subnet Mask
,
Default Gateway
, and
DNS Server
settings will be displayed.
Note down the IP address displayed in the
IP Address
row.
6. Go back to
Advanced Menu - System > Network
>
Wired LAN
page.
7. Press to highlight
AMX Device Discovery
and press / to select
On
or
Off
. When
AMX
Device Discovery
is
On
, the projector can be detected by AMX controller.
If you are in a non-DHCP environment:
1. Go to
Advanced Menu - System > Network
>
Wired LAN
page.
2. Press to select
DHCP
and press / to select
Off
.
3. Contact your ITS administrator for information on the
IP Address
,
Subnet Mask
,
Default
Gateway
, and
DNS Server
settings.
4. Press
to select the item you want to modify and press
OK
.
5. Press / to move the cursor and then press / to enter the value.
6. To save the setting, press
OK
. If you do not want to save the setting, press
BACK
.
7. Press to highlight Apply and press
OK
.
8. Go back to
Advanced Menu - System > Network
>
Wired LAN
page., press to highlight
AMX Device Discovery
and press / to select
On
or
Off
.
9. Press
MENU
to exit the menu.
• When connecting the RJ45 cable, avoid coiling and intertwining the cable as it may cause signal noise or
interruption.
• If the IP Address still does not display, contact your ITS administrator.
