25
EN
Remote controls quick duplication
If you have a transmitter that is already memorised (TX1), it can be duplicated (TX2) without accessing the control unit for programming, proceed as follows:
1
Give an opening command and wait till the leaf is in full opening position using a transmitter already stored in memory (TX1), (TCA
function must be enabled ).
PMOT
2
Press the hidden key of the transmitter ,the code of which has already been stored in memory (TX1)
TX1
3
Within 5 seconds ,press the already memorized transmitter key corresponding to the channel to be matched to the new transmitter.
The flashing light switches on.
TX1
4
Within 10 seconds ,press the hidden key of the new transmitter (TX2).
TX2
5
Within 5 seconds ,press the key of the new transmitter to be matched to the channel to be matched at the item 2 ,the flashing light
switches off.
TX2
6
The receiver stores the new transmitter code and exits from the programming mode immediately.
Complete deletion of the receiver memory (RADI>RTR)
To delete the memory completely, eliminating all previously-inserted remote controls, proceed as follows:
1
Press the [PGM] button to access programming or if the control unit is already in the programming menu, press [
] until the Radi
menu is displayed.
PMOT
Radi
2
Press the [PGM] button to enter the Radi function.
The display shows the first sub-menu PP.
Press [
] three times to display the RTR sub-menu
rtr
3
Press the [PGM] button to enter the RTR function, the RTR message starts to flash slowly.
Press [PGM], the PRG message is displayed and deleting starts.
4
When the PRG message switches off, the display shows the OK message for about 2 seconds. All remote controls are now deleted
from the memory.
PRG
6
The control unit goes back to the RADI>RTR menu. To go back to the RADI menu, press the [PGM] and [
] buttons at the same time.
To exit programming, press the [PGM] and [
] buttons at the same time again or, alternatively, remove the power supply or wait 60
seconds.
PGM+
ARC compatible control unit
IMPORTANT, PLEASE READ CAREFULLY:
The radio receiver in this product is compatible with the new ARC (Advanced Rolling Code) transmitters which, thanks to 128-bit encryption ensure superior copy-security.
Storing new ARC transmitters is quite similar to that of normal rolling code transmitters with HCS coding, but be aware that:
1) ARC transmitters and Rolling Code HCS can not be stored in a single receiver.
2) The first transmitter memorized determines the type of transmitters to be used later. If the first transmitter memorized is ARC, you can not store Rolling code HCS transmitters,
and vice versa.
3) Fixed code transmitters may only be used in conjunction with Rolling code HCS transmitters. They are, therefore, not usable in combination with the ARC transmitters.
4) If you want to change the type of transmitters it is necessary to proceed with a receiver reset (as described in the manual).
Summary of Contents for 9592170
Page 2: ......
