In case of grounding the pin is designed to break and prevents structural damage of the boat.
LAUNCHING OF FIRST 18
Launching of First 18 is easy and similar to the launching of the other boats on the trailer. However,
you need to be careful about following specifics and tricks.
1.
Just before the launching ramp completely lifts the keel. The keel is entirely lifted when you
can not turn the handle any more.
WARNING: keel needs to rest on the trailer keel support during road transport. Lift it just
before the launching ramp.
2.
Remove the lights from the trailer and pull the electric cable to the front. Provisionally tie it
for the mast support, high enough that it will not get in touch with the water.
3.
Do not leave the rudder blades laying on the cockpit floor. They'll likely slide into the water
and get damaged.
4.
Install fenders and mooring line before launching of the boat.
5.
For easy launching of the First 18, the stern of the boat needs to float. How much you will
need to submerge the trailer depends on the angle of the slipping ramp. If the launching
ramp is very slight, you might need to use extension rope between the car and the trailer.
6.
When stern afloat, unhook the boat from the trailer winch and push the bow off the trailer.
Help yourself by lifting the bow over the extended bowsprit.
After launching of the boat in salty seawater, always extensively wash the trailer with the freshwater,
especially wheels bearings.
Summary of Contents for First 18
