29
OPERATION
To Raise Lift;
Load vehicle onto the lift using Vehicle Lifting Guide to
determine proper lifting points.
.
Set parking brake or use wheel chock to hold vehicle
in position.
Before raising vehicle, be sure all personnel are clear
of the lift and surrounding area. Pay careful attention to
overhead clearances.
Raise the lift to the desired height by pressing the push
button on the power unit.
After vehicle is raised to the desired height,
lower the
lift onto the nearest safety lock.
Do not allow cables to
become slack.
ALWAYS INSURE SAFETY LOCKS ARE
ENGAGED
before entering work area.
To Lower Lift;
Raise the lift off the safety locks by pressing the push
button on the power unit. Make sure you raise the lift by at
least two inches to allow adequate clearance for the locks
to clear.
Push the powerside safety handle and HOLD.
Push the LOWERING HANDLE on the power unit until
the lift has descended completely.
WEEKLY MAINTENANCE
Lubricate all rollers with general purpose oil or WD-40.
Check all cable connections, bolts and pins to insure
proper mounting.
Lubricate safety lock pivot points with general purpose
oil or WD-40.
MONTHLY MAINTENANCE
Check safety locks to insure they are in good
operating condition.
Check all cables for excessive signs of wear
Make a visual inspection of ALL MOVING PARTS and
check for excessive signs of wear
Replace ALL FAULTY PARTS before lift is put back
into operation.
NEVER EXCEED THE RATED CAPACITY
of lift.
DO NOT USE LIFT
if any component is found to be
defective or worn.
NEVER OPERATE LIFT
with any person or equip-
ment below.
ALWAYS STAND CLEAR
of lift when lowering or
raising.
ALWAYS INSURE SAFETY LOCKS ARE ENGAGED
before entering work area.
NEVER LEAVE LIFT IN ELEVATED CONDITION
unless all four safety locks are engaged
When lowering the lift PAY CAREFUL ATTENTION that
all personnel and objects are kept clear. ALWAYS keep
a visual line of site on the lift AT ALL TIMES. ALWAYS
make sure that all FOUR LOCKS are disengaged. If one
of the locks inadvertently locks on descent the lift and/or
vehicle may disrupt causing personal injury or death.
VISUALLY CONFIRM THAT ALL PRIMARY
SAFETY LOCKS ARE ENGAGED BEFORE
ENTERING WORK AREA.
Suspension components us on this lift are
intended to raise and lower lift only and are not
meant to be load holding devices. Remain
clear of elevated lift unless visual confirmation
is made that all primary safety locks are fully
engaged and the lift is LOWERED onto the
safety locks, Refer to installation /operation
manual for proper safety lock procedures
and /or further instruction.
