BendPak RBJ15000, Installation And Operation Manual

Page: 9 / 32

RBJ Series of Rolling Jacks
9
P/N 5900004 — Rev. D1 — October 2020
Specifications
Model RBJ15000 RBJ18000 RBJ25000
Lifting capacity 15,000 lbs / 6,804 kg 18,000 lbs / 8,165 kg 25,000 lbs / 11,340 kg
Min. Drive-Over
Height (with Short
Arm Pad)
9" / 229 mm 9" / 229 mm 9" / 229 mm
Max. Lifting Height
(with Short Arm Pad) 19" / 483 mm 19" / 483 mm 19" / 483 mm
Minimum arm reach 39.4" / 1,003 mm 39.6" / 1,008 mm 39.6" / 1,008 mm
Maximum arm reach 63.75" / 1,618 mm 63.5" / 1,612 mm 63.5" / 1,612 mm
Supported base
widths
~45.75" / 1,163 mm to
~58.5" / 1,489 mm
~45" / 1,140 mm
(fixed)
~45" / 1,140 mm
(fixed)
Maximum operating
hydraulic pressure 6,000 PSI 7,200 PSI 8,050 PSI
Shipping weight 698 lbs / 259 kg 777 lbs / 358 kg 819 lbs / 363 kg
Specifications are subject to change without notice.
About Vehicle Wheelbases
A BendPak four-post Lift supports less weight than its rated capacity when the wheelbase of the
Vehicle on the Lift is shorter. This is because the wheels of these shorter wheelbase Vehicles are closer
to the middle of the Runways, where there is less strength. Consequently, the rated capacity of that
Lift is less for these shorter wheelbase Vehicles.
For example, if you want to raise a Vehicle with a wheelbase of 100" on an HDS-14LSX Lift, the rated
capacity of the Lift is reduced by 50% to 7,000 lbs (3,175 kg).
Rated capacity information is included in the Specifications section in the manual of all four-post Lifts.
Refer to the manual of a specific Lift for rated capacity information for that Lift.
This reduced capacity based on Vehicle wheelbase does not impact the rated capacity of the Rolling
Bridge Jacks used on those Lifts. Nevertheless, make sure to always check the rated capacity of the
Lift your Rolling Bridge Jacks are being used on to make sure you do not exceed the rated capacity of
the Lift.