RBJ Series of Rolling Jacks
12
P/N 5900004 — Rev. D1 — October 2020
•
The Lift Runways
must
be parallel
. Make sure the Lift Runways were installed parallel to
each other. The distance between the Lift Runways
must be equal
along the entire length of the
Lift.
In the following drawing, the distance between the Runways at Points A, B, and C
must
be the
same. If they differ, moving the Rolling Bridge Jack will be much more difficult.
⚠
WARNING
If the Lift Runways are
not
parallel, moving the Rolling Bridge Jack could force it off
the Utility Rail, increasing the chances it could fall and be damaged or cause injury.
If Lift Runways are not parallel, take the Lift out of service and get it adjusted so that
the Lift Runways are parallel. Then you can use your Rolling Bridge Jack on the Lift.
Not necessarily to scale. Not all components shown.
Summary of Contents for RBJ15000
