RBJ Series of Rolling Jacks
14
P/N 5900004 — Rev. D1 — October 2020
Moving the Rolling Bridge Jack into Position
Rolling Bridge Jacks need to be moved into position using a Forklift, Shop Crane, or other device
appropriate for lifting
heavy
loads.
⚠
WARNING
Pay close attention when moving the Rolling Bridge Jack into position; it could shift,
possibly causing injury. Prior to moving it, make sure the Rolling Bridge Jack is held
securely
by a Forklift, Shop Crane, or other device used for lifting heavy objects.
The following procedure includes instructions for all three Rolling Bridge Jacks: the RBJ15000,
RBJ18000, and the RBJ25000.
The procedure is slightly different for the RBJ15000 because it has Extendable Bases and Adjustment
Bolts, which the other two models do not.
To move a Rolling Bridge Jack into position on a Lift
:
1.
Make sure the
Lift
is either fully lowered or engaged on Safety Locks.
2.
If you are installing an
RBJ18000
or
RBJ25000
, make sure the Lift’s Runways are as far apart
as possible.
Measure the distance between the two Runways to make sure they are ~47 inches / ~1,199 mm
apart.
3.
If you are installing an
RBJ15000
, set the Lift’s Runways to the desired distance apart, from
~45.75 inches / 1,163 mm to ~58.5 inches / 1,489 mm.
4.
Make sure the Utility Rail Channel is clear of all debris.
5.
Using a Shop Crane, Forklift, or other lifting device, raise the Rolling Bridge Jack and orient it
above and between the Lift’s two Runways.
Do not lower it onto the Utility Rail yet
.
Remember to orient the Air-Operated Hydraulic Pump side appropriately: orient the Pump side of
the Rolling Bridge Jack towards the Crosstubes/outside of the Lift (
not towards the inside
).
6.
Lower the Rolling Bridge Jack to just above the Utility Rails between the Lift’s Runways.
Do not
lower it onto the Utility Rails yet
.
The following drawing shows the Channel Roller of an
RBJ18000
or
RBJ25000
sitting directly
over the Utility Rail Channel.
Not necessarily to scale. Not all components shown.
Summary of Contents for RBJ15000
