RBJ Series of Rolling Jacks
18
P/N 5900004 — Rev. D1 — October 2020
3.
Press and hold the
RELEASE
end to lower the Jack down onto the closest Safety Lock.
4.
Release the
RELEASE
end of the Pump when the Safety Lock engages on the Safety Lock Pin.
This drawing shows, on the Left, the Jack between the two Safety Lock positions; the Safety Lock
is
not
engaged on the Safety Lock Pin. On the right, however, the Safety Lock is engaged on the
Safety Lock Pin.
⚠
WARNING
Only leave your Rolling Bridge Jack engaged on a Safety Lock or fully lowered.
5.
To lower the Rolling Bridge Jack from a Safety Lock: press the
PUMP
end of the pedal to move it
up and off the Safety Lock Pin, pull the Safety Handle away from the Safety Lock (towards the RBJ
Structure), then press and hold the
RELEASE
end of the pedal.
The Rolling Bridge Jack begins lowering. Because
the Safety Handle is holding the Safety Lock up
and away from the Safety Lock Pin
, the Safety Lock will not engage on the Safety Lock Pin.
6.
When the Jack is fully lowered, wait two seconds, then release the
RELEASE
end of the pedal.
Assuming the test went fine, your Rolling Bridge Jack is ready for normal operation.
If there were issues, resolve the issues before beginning normal operation. You can refer to
Summary of Contents for RBJ15000
