BendPak LR-60, Installation And Operation Manual, Page: 31 / 44

LR-60/60P Low-Rise Scissor Lifts
31
P/N 5900337 — Rev. F — December 2020
12. On the Power Unit, press and hold the Raise button.
13. Watch the Vehicle and the Platforms as they rise.
If the Lift becomes unstable or the Vehicle starts moving, release the
Raise button immediately.
14. When the Platforms are just past the desired height, release the Raise button.
The Lift stops rising.
15. Press the Lowering Handle to move the Platforms back down, which engages them on the most
recently passed Safety Lock.
If you miss the Safety Lock, press and hold
Raise again and go somewhat further past the Safety
Lock, then hold the Lowering Handle again to engage the Lift on the Safety Lock.
16. Rock the Vehicle to make sure the Vehicle is stable and balanced.
If the Vehicle is
not
stable and balanced, lower the Lift back to the ground and start over.
If the Vehicle is stable and balanced, it is safe to begin working on your Vehicle.
Lowering a Vehicle
This section describes how to lower a Vehicle from a raised position.
To lower a Vehicle :
1. Check the items listed in Lift Operation Safety .
If you find any issues, resolve them before lowering the Vehicle.
Only use the Lift if it can be used safely .
2. Press and hold the Raise button for a second or two to move the Platforms off the Safety Lock.
3. Move the Safety Lock Release Handle to the Raised position (which pushes the Safety Lock Bar
up, allowing the Safety Locks to be passed by).
4. Press and hold the Lowering Handle.
5. Release the Lowering Handle when the Lift is fully lowered.
6. Move the Safety Lock Release Handle back to the Lowered position.
7. Carefully drive the Vehicle off.