LR-60/60P Low-Rise Scissor Lifts
29
P/N 5900337 — Rev. F — December 2020
Operation
This section describes how to operate your Lift.
⚠
DANGER
Using an Automotive Lift is a serious endeavor with potentially life-threatening risks.
Only trained, authorized, supervised personnel may be within 30 feet of the Lift
while it is in use.
Do not assume you are going to be safe using the Lift
this time just because nothing happened last time
.
Lift Operation Safety
BendPak recommends referring to the ANSI/ALI ALIS Standard (R2015)
Safety Requirements for
Installation and Service
, available from the Automotive Lift Institute store (
), for
more information about safely installing, using, and servicing your Lift.
Before you raise or lower a Vehicle using your Lift, do the following each time:
•
Check the Lift
. Check the Lift for any missing, heavily worn, or damaged parts. Do not operate
the Lift if you find any issues; instead, take it out of service, then contact your dealer, email
, visit
, or call
(800) 253-2363
, x196.
•
Check the area
. Check the area around the Lift for obstructions; anything that might block the
Lift. Do not forget to check
above
the Lift. If you find an obstruction, move it out of the way.
•
Check the operators
. Make sure everyone who is going to operate the Lift has been trained in
its use, has read the labels on the unit, and has read the manual. Only the operator at the Console
should be within 30 feet of the Lift when it is in motion.
•
Check for safety
. Make sure everyone who is going to be walking near the Lift is aware of its
presence and takes appropriate safety measures. Only put Vehicles on the Lift.
When raising
the Lift, do not leave it until it is engaged on a Safety Lock
. When lowering the Lift, do
not leave it until it is fully lowered. Do not allow children or untrained personnel to operate the Lift.
Do not allow anyone under the influence of drugs or alcohol to operate the Lift.
•
Check the Vehicle
. Never exceed the Lift’s weight rating. Do not allow people inside a Vehicle
you are going to raise. Before raising it, make sure the Vehicle is not overbalanced on either end.
Make sure you know and use the manufacturer’s recommended Lifting Points for the Vehicle.
Never raise just one side, one corner, or one end of a Vehicle.
Lift Controls
The controls on the Lift are:
•
Raise
Button. Moves the
Platforms up. Located near the
top of the Power Unit.
•
Lowering Handle
. Moves the
Platforms down. Handle with
round ball at end, located near
the middle of the Power Unit.
Summary of Contents for LR-60
