Bender FTC470XET, Operating Manual

Page: 21 / 84

Installation
21 TGH1375en/02.2010
Confirm your correct entries with "OK". Close the other windows with OK, if required with "Close".
After adapting your PC to the network parameters of the FTC470XET, the PC can address the
protocol converter by means of the Web browser (Internet Explorer etc.).
5.1.4 Setting the IP address and network mask of the FTC470XET
The following settings can be carried out in two steps.
First address the protocol converter with its factory-set IP address.
Then call up the parameterisation window in order to assign a new IP address to the device
for its network environment.
Proceed as follows:
1. As soon as the green LEDs LINK and ON light permanently, you can proceed.
2. Start the browser of your PC. Enter the following address into the address field of the browser:
http://192.168.0.254
When each step of the procedure described above is correctly performed, the start page of the inter-
nal Web server appears.
3. Click on "Password for parameter setting"
Enter the password into the edit field:
ftc
Confirm with "Send"
Now you have access to the parameterisation functions.
4. Click FTC470XET (mostly address 1) in the BMS Explorer in order to view the sub menu items. Then
select "Set network parameters", the appropriate window will appear.
5. By way of example, it is assumed that you have received the following network data for the
FTC470XET from the person responsible for the installation:
IP address: 172.16.10.54
Network mask: 255.255.0.0
Enter these data into the white edit fields.
Confirm with "Save". After a few seconds the accepted data will be displayed.
6. Click "Restart". After approximately four seconds, the flashing ON LED at the device signals restart
and the communication between the browser and the Web server is interrupted, because the Web