15
Bell
fi res
English
Instructions for use and installation instructions
Manual operation
Here you can turn the burner on and off, and adjust the height of the fl ames.
• Press (large fl ame) to turn on the burner and to increase the fl ame
height.
• Press (small fl ame) decrease the fl ame height to turn the burner off.
The pilot light will keep burning. (Stand-by position)
• The appliance will automatically revert to stand-by if the hand-held
transmitter is not operated for more than 6 hours.
• When one of the
button
s on the hand-held transmitter is pressed (except
the
SET
button
), the transmission symbol appears on the screen.
The receiver confi rms the transmission with an audio signal.
Operating day temperature thermostat
(Appliance is in the stand-by position and the pilot light is burning.)
Automatic temperature regulation of the pre-set day temperature.
The room temperature is measured and compared with the pre-set day
temperature. The fl ame height is automatically regulated so as to reach the
pre-set day temperature.
Also see:
Setting the desired temperature
.
Operating the night temperature thermostat
(Appliance is in the stand-by position and the pilot light is burning.)
Automatic temperature regulation of the pre-set night temperature.
The room temperature is measured and compared with the pre-set night
temperature. The fl ame height is automatically regulated so as to reach the
pre-set night temperature.
Also see:
Setting the desired temperature
.
Timer operation
(Appliance is in the stand-by position and the pilot light is burning.)
Appliance functions automatically according to the two pre-set heating periods;
P1 and P2. These heating periods repeat automatically every 24 hours.
Also see:
Programming the timer: P1 and P2.
The appliance works thermostatically at the pre-set starting times P1 and
P2 and the room temperature is automatically regulated to the pre-set day
temperature .
The appliance works thermostatically at the pre-set stopping times P1 and
P2 and the room temperature is automatically regulated to the pre-set night
temperature .
In order to allow the appliance to regulate the temperature at night, the night
temperature must be set to at least 5°C.
If the setting is lowered to , the appliance will switch to stand-by
at night. The appliance will automatically operate at the following day cycle
.
N.B.: The pre-set temperature is shown on the screen every 30 seconds.
