Configuring the XIP-3901-UDC-IP Application
INSTALLATION AND OPERATION GUIDE
XIP-3901 | 87
Property
Description
Video Format
Shows
the video source stream’s format (resolution / frame rate).
Colorimetry
Shows the colorimetry and Transfer Characteristics System (TCS) information extracted from
the associated SDP file for the selected SMPTE 2110 stream allowing for a constant update
between a sender and a receiver.
In the absence of valid SDP contents, use the dropdown list to manually set the stream
colorimetry type.
Audio
Type:
Use the pull-
down to set the audio source stream’s type for streams
Audio 1
to
Audio
4
.
Type SMPTE ST 2110-30
: for PCM linear audio (AES67 compatible)
Type SMPTE ST 2110-31
: for transparent transport of non-linear audio and data formats:
provides bit-transparent AES3 over IP
Profile:
Use the pull-down to set the audio profile for streams
Audio 1
to
Audio 4
. Audio
receivers support Level C as per SMPTE 2110-30/31: 48kHz stream from 1 to 8 channels (1
to 4 for SMPTE 2110-31) at packet times of 1ms and 1 to 64 channels (1 to 60 for SMPTE
2110-31) at packet time of 125us.
These settings can also be managed by external NMOS control. See 10.3 - NMOS Panel on
page 84.
Master
Set to enable a media receiver. This manages the Join/Release of both the primary and
secondary streams.
These settings can also be managed by external NMOS control. See 10.3 - NMOS Panel on
page 84.
Media
Shows the stream type. The background shows the current media status:
Green:
no error
Red:
error
Grey:
inactive
RTP Stream
Set to enable each stream receiver individually (primary and secondary).
Stream
Shows the primary (ETH1) and secondary (ETH2) stream receiver status:
Green:
no error
Red:
error
Grey:
inactive
IGMPv3
Source
Set the source from which to receive multicast streams. With this protocol, the card deals with
a switch to subscribe to one or many streams that are coming from different sources.
Both iGMPv3 and iGMPv2 protocols are supported. Set this to 0.0.0.0 if iGMP source is not
used. The source range is 0.0.0.0 to 255.255.255.255. The default value is 0.0.0.0.
These settings can also be managed by external NMOS control. See 10.3 - NMOS Panel on
page 84.
RX Stream
Address
Set the IP address and UDP port number at which this card receives a specific stream. IP
address 0.0.0.0 disables a receiver. The default UDP port values are: 10000 for all media
receivers.
These settings can also be managed by external NMOS control. See 10.3 - NMOS Panel on
page 84.
RX Stream
Port
SDP File
Click to show the last SDP file received through NMOS IS-05 since the last bootup. This
window does not refresh automatically; you need to close and re-open the window to see an
update. If the card has never received an SDP file since last its last bootup, the window will
be empty.
Apply
Cancel
When active, this applies or rejects your current changes made in this tab except for Audio
type and Profile
