GUIDE TO INSTALLATION AND OPERATION
FIO-1901-R |
3
2 Installation
Miranda Densité-series cards are each associated with a rear connector panel, which must be installed in the Densité
frame before the card can be inserted.
The FIO-1901-R card is sized to fit into Miranda’s Densité-2 frame. One rear connector panel is available to fit the
Densité 2 frame:
•
FIO-1901-R-SRP – 1 fiber input and 2 electrical outputs
See section 2.1 below for installation instructions.
With the use of available adapters, the FIO-1901-R and its rear panel can also be installed in a Densité-3 frame. See
section 2.2 below for details.
2.1 Installation in a Densité-2 frame
All cards and rear panels can be installed with the frame power on. The card has connectors which plug into a mid-
frame mother board for distribution of power and for connection to the controller card, and a second connector which
plugs directly into the rear connector panel for input and output.
The rear connector panel must be installed with the card out of the frame.
- To remove an existing card from the slot, tilt up the swivel handle on the front of the card to lever the connectors
apart, then use the handle to pull the card straight out of the slot.
Installing the connector panel:
1. If a card is installed in the slot whose rear panel is being changed, remove it as described above.
2. Remove the existing panel (either blank or belonging to an existing card that is being changed) by releasing the
captive screw(s) at the bottom.
3. Position the new panel and secure it in place with the captive screw(s) at the bottom.
Densité-2 frame – rear panel installation
