GUIDE TO INSTALLATION AND OPERATION
FIO-1901-R |
9
3.2.3.1 Reclocker
Enable reclocking of the video data stream arriving at the optical receiver. The reclocker operates at the video
standard rates of SD (270Mbps), HD (1.49Gbp), and 3G (2.97Gbps).
Optical Rx:
[ON, BYPASS]
3.2.3.2 User Presets
The FIO-1901-R has five data storage registers that can save the device configuration. Each register can be saved
independently by the user, and the device can be reconfigured from the contents of any of the registers by the user.
LOAD: [USER1, USER2, USER3, USER4, USER5] Load the contents of the preset into the FIO-1901-R
SAVE: [USER1, USER2, USER3, USER4, USER5] Save the configuration of the FIO-1901-R into the preset
3.2.3.3 Configure Alarms
For each of the configurable alarms listed in the menu:
OPT Rx NO LOCK
(Optical receiver not locked)
OPT Rx NO SIGNAL
(Optical receiver no signal)
OPT Rx PWR WARN
(Optical receiver power warning)
OPT Rx PWR ERR
(Optical receiver power error)
SFP TEMPERATURE
(temperature on the SFP module)
R/SFP MISMATCH
(any mismatch between the card type / rear panel type / installed SFP module type)
NO SFP
(no SFP module installed)
Select the way in which it will be displayed on the card-edge Status LED.
Alarm level: [GREEN, YELLOW, RED, FLASH RED]
For each alarm, select whether it will be reported on the GPI output of the frame controller.
Alarm report: [NONE, GPI]
