Belden 934 691-001, Technical Manual

Page: 61 / 68

Technical data
Technical manual LioN-P/ -R EtherNet/IP
Release 1.4 02/2016
10.7 LEDs
61
U
L
Green Actuator power supply, voltage level 18 V <= U
L
<= 30 V
Red Actuator power supply, voltage level U
L
< 18 V
or U
L
> 30 V
Off No actuator power supply
X1…X8
A/DIA Yellow Channel status A “On”
Red Periphery error (sensor or actuator
overload/short-circuit)
Off Not connected, status “Off”, no error
X1…X8 B White Channel status B “On”
Red Periphery error (actuator overload/short-circuit)
Off Not connected, status “Off”, no error
P1 Lnk/Act
P2 Lnk/Act Green Ethernet connection exists to another
subscriber. Link connection created.
Flashing yellow Data exchange with another subscriber.
Off No connection to another subscriber. No link,
no data exchange.
MS Green Device ready for operation.
Flashing green Device ready but not configured.
Red Serious error that cannot be resolved
Flashing red Minor error that can be resolved
Example: An incorrect or contradictory
configuration is classified as a minor error.
Alternately flashing red/green The device is performing a self-test.
Off
Device is switched off.
NS Green Connected: The device has at least one
connection.
Flashing green No connection: The device has no connections.
IP address exists.
Red Duplicate IP address. The device has detected
that the assigned IP address is already being
used by another device.
Flashing red Connection has exceeded time limit or
connection interrupted.
Alternately flashing red/green The device is performing a self-test.
Off
The device is switched off or does not have an
IP address.
Table 35: Information on the LED colors