QUICKFIRE®
Signature
®
Series
68
Belanger, Inc. * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681
1MANUL826
Maintenance
General Replacement Information
Spherical Bearing Replacement Tip: Electric
Note:
When replacing the Electric Motor, Four-Bolt bearings, or adjusting to the Torque Plate
be sure not to over tighten the bolts that go through the Spherical Bearing doing so may
damage or crack the bearing.
When tightening the long bolts on the Spherical Bearing, tighten until the bolt barely touches the bearing. Over
tightening may damage or crack the bearing.
Head Assembly Bearing Adjustment
If for any reason the Head Assembly has to be removed, after replacing it adjust the height of
the Head Assembly to the location described below by tightening or loosening the nuts on the
underside.
Head Spherical Bearing Plate
Spherical Bearing
Se
t between 1/8” t
o 3/16
” b
etween
the tube and the skid plates
Tighten or loosen these nuts to adjust height.
Once set, be sure to tighten the locking nut.
Adjust height at all four locations.
