Belanger Fusion X2 PRO, Owner'S Manual

Page: 31 / 68

FUSION
™ CARWASH CONTROLLER
1MANUL965 Belanger, Inc. * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681
4-7
Chapter 4 Operator Interface/Standard Wash Operation Screens
User
User / Input Bypass
Input Bypass is a method to temporarily not use an input (sensor) that may not be performing properly. Typically,
the bypass settings are set prior to sensor failure for quicker response to adapting to it. Review and understand all
Loading Setup Settings before configuring Bypass Settings.
User / Input Bypass / Enter Photo - Edit
To bypass bay enter photo-eye, adjust RUN WAY DISTANCE to enable photo-eye at an average distance from
dollie up to simulate vehicle breaking photo-eye beam. Adjust MAX CAR LENGTH to simulate a vehicle length that
all vehicles will be measured during bypass. Usually this is set to size of typical SUV.
Screen Key:
•
This screen is for temporarily bypassing the
corresponding Input that may be causing issues.
•
Pressing the ENABLE button will change behavior to
bypass the corresponding Input. This means it will
run in the BYPASS manor as setup by pressing the
EDIT key.
Screen Key:
• NORMAL : This is the data entered into the
Loading Setup screen and will be utilized for
normal operation.
•
BYPASS : This is the data entered into this
screen and will be utilized when ENTER
PHOTO BYPASS is active.