Belanger Fusion X2 PRO, Owner'S Manual

Page: 45 / 68

FUSION
™ CARWASH CONTROLLER
1MANUL965 Belanger, Inc. * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681
5-9
Chapter 5 Operator Interface/Wash Setup Screens
Setup
Setup / Loading
•
RUNWAY DISTANCE : The system will not evaluate the “Entrance Photo - Eye” until the “Runway Distance”
has expired after the “Dollie Up” function. This setting helps properly size a vehicle when it pulls into the
“Entrance Photo - Eye” before th e dollie reaches the tire.
If the wash is configured “Front Tire Pull”, we suggest it be set to a distance of 50 inches less than the distance
from the “Dollie Up” location to the entrance Photo - Eye. If the wash is configured “Rear Tire Push”, we suggest
t hat it be set to a distance of 237 inches less than the distance from the “Dollie - Up” location to the Entrance
Photo-Eye. FAILURE TO SET AS RECOMMENDED OR SMALLER WILL SEVERELY INHIBIT LOADING
PERFORMANCE.
•
ENTER PHOTO-EYE DISTANCE : The dollie will be canceled when the dollie is raised and travels the Photo-
Eye distance without breaking the “Entrance Photo - eye”. This should be set to the distance between the
“Entrance Photo - Eye” and the “Dollie Up” location. If set to Front Tire Pull with two front tire doll ies, add dollie
spacing distance to the recommended settings stated. FAILURE TO SET AS RECOMMENDED OR LARGER
WILL SEVERELY INHIBIT LOADING PERFORMANCE.
•
REPEAT SIZE DOLLIE : This function toggles back and forth between “Enabled” and “Disabled”. When
ENABLED, the system will recall that Dollie for its designated tire if the Dollie travels past the enter Photo-
Eye distance without the Photo-Eye being broken by a vehicle.