Belanger Fusion X2 PRO, Owner'S Manual

Page: 43 / 68

FUSION
™ CARWASH CONTROLLER
1MANUL965 Belanger, Inc. * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681
5-7
Chapter 5 Operator Interface/Wash Setup Screens
Setup
Setup / Basic Functions
Setup / Function / Any Base Function
Functions
These functions turn ON/OFF at positions determined by that f unction’s parameters.
Below is a summary of the User Defined settings that can be programmed in Functions.
•
NAME : Touch the “NAME” for the alpha/numeric pop -up to display for changing the name. Not all Functions are user
namable.
•
ON POSITION : This dictates the tunnel location that a function will turn ON (from the “Entrance Photo - Eye” to the
desired “ON” point). Minimum setting is 8 inches. Length Adjust : This is to adjust the distance that the function will
be ON. This can be +/- of the measured car length.
•
LOOKBACK DISTANCE : This will keep the Function active if next vehicle is within Lookback distance. This setting
does NOT work when the Function is in “Set Distance” .
• ON/OFF FOR ANTI-COLLISION : Toggles between ON or OFF during Anti-Collision condition
Screen Key:
•
Pressing the corresponding button will navigate to
the Setup Screen for that Function.