Beko Arcelik BLG15 C7S, Service Manual, Page: 24 / 72

BLG15 C7S SERVICE MANUAL
Sensitivity: Public
Step 14: Hot water valve check
Description:
The valve will be activated if a hot water valve is predefined.
On products without an FM, the machine will take in water until the key is pressed.
On products with an FM, the machine will take in water for 10 seconds. If it reaches
50 pulses within this period, step transition will be allowed.
Step transition is not allows during water level measurement.
Position to turn the knob to
4 for water level sensor details; 7 for FM details
Warnings to be displayed on the 7S:
Refer to the knob position and information table
Condition to pass to the next step:
Machine will take in water until "Start/Pause" button is pressed.
Timeout: If "Start/Pause" button is not pressed within 2*3 = 6 minutes, it goes into
"OFF" mode.
Switching to next step:
"Start/Pause" button is pressed.
NOTE: If you turn the knob to Off position, the machine will switch to "OFF" mode.
Step 15: Heater check, Water level sensor check
Jet system check, Motor clockwise wash check
Description:
If the water level is lower than 'Psafety - 20.0 Hz' in terms of frequency (if there is
water above this level), heater will be activated.
If the water level is higher than 'Psafety - 20.0 Hz' (if there is water below this level),
all valves will be opened, water level will be completed and then the heater will be
activated automatically.
Jet pump will also be activated along with the heater if defined in the machine.
Motor will be rotated clockwise at 52 rpm.
Psafety level is found in the variable file.
The level which is defined in this step is a level between the Psafety level and the
Pdoor level.
Position to turn the knob to