Beissbarth MT 788, Original Instructions Manual

Page: 31 / 292

932 655 638 2014-02-14
|
Beissbarth GmbH
Commissioning | MT 788 | 31 en
4.4 Electrical connection
DANGER – Risk of electric shock if connec-
tions are not or not correctly grounded or
from incorrect mains voltage.
Incorrect phase, neutral and ground connec-
tions can cause electric shocks, heart failure
and fatalities!
¶
Work on electrical installations or equip-
ment is only to be performed by qualified
electricians or trained personnel under the
guidance and supervision of an electrician.
¶
Even minor work on the electrical system
is only to be performed by appropriately
trained and qualified personnel.
¶
The MT 788 is only to be connected to the
power supply if the mains voltage available
corresponds to the rated voltage given on
the rating plate.
¶
Check the grounding before connecting
the MT 788.
¶
Use the type of power cord specified for
the country concerned.
¶
Only connect to an appropriate approved
grounding-type socket.
¶
In the event of operating problems, switch
off immediately by way of the On/Off
switch, disconnect the power cord and
consult the "Faults" section of the opera-
ting instructions.
i
The MT 788 must be connected to a standard electri-
cal system provided with a residual-current-operated
circuit breaker with a connection cross-section of at
least 3 mm conforming to European standards. The
customer is responsible for providing fuse protection
for the mains connection.
i
The MT 788 is connected to the mains by way of a
socket. For this purpose use is to be made of the
detachable cable with standard connector supplied
with the device. The connector must always be readi-
ly accessible.
i
A two-pole residual-current-operated circuit breaker
of type "C" must always be used to provide fuse pro-
tection for the mains connection. Single-pole circuit
breakers are not permissible.
i
The temperature and ambient conditions specified in
the Technical Data must be observed for operation.
651012-04 _Sr
1
2
3
Fig. 3: Power cord connection - Back of MT 788
1 On/off switch
2 Mains connection
3 Power cord