Hardware
30
Beijer Electronics, MA00757A
EXTER K70 and T70
To replace the display/display cable you will need a new display including plastic
frame and display cable, see the
Follow the steps below:
1. Power off the operator terminal.
2. Follow the instructions under
to remove the rear cover.
3. Disconnect the two (EXTER T70) or three (EXTER K70) flex cables from the
power card, according to the illustration below, and remove the two plastic nuts
that holds the power card in place.
Illustration of EXTER T70 showing the two flex cables
Illustration of EXTER K70 showing three flex cables
4. Lift the power card and gently remove the backlight cable from the rear side.
5. Gently loosen the complete plastic frame and display from the front plate.
Scrap the display and frame.
6. Mount the new display/display cable and frame and re-assemble the complete
operator terminal. Make sure the guide pins on the frame are properly fastened
in the holes in the front plate.
7. Re-assemble the complete operator terminal.
plastic nut
flex cables
plastic nut
plastic nut
plastic nut
flex cables
backlight cable
snap-in closure for plastic frame
guide pins
guide pins
