Hardware
Beijer Electronics, MA00757A
29
EXTER T60c/T60m
To replace the display you will need a new display including display frame, see
the
section.
Follow the steps below:
1. Power off the operator terminal.
2. Follow the instructions under
to remove the rear cover.
3. Unlock the two flex cable connectors by pressing the connector flanges towards
the cable and disconnect the flex cables and the plain cable from the power card.
The connectors must be unlocked on both sides before removing the cables.
4. Gently press the power card towards the top of the terminal as shown in the
illustration above to release the power card from the power card holders.
Then tilt the bottom of the card away from you.
5. Disconnect the plain cable on the back side of the power card and then remove
the power card.
6. Insert the two screwdrivers between the display frame and the aluminum casing
illustrated below. Press and bend gently on the display frame to unlock the frame
and tilt up the display frame.
7. Mount the new display unit.
8. Re-assemble the complete operator terminal.
plain cable
power card
flex cables
display frame pressure points
