Hardware
38
Beijer Electronics, MA00757A
EXTER K70, EXTER K100, EXTER T70, EXTER T100 and EXTER T150
The following is needed:
– A new battery, see the
list.
– Glue Gun: Jet-Melt TCQ, manufacturer: 3M
– Melting Glue: 3748 V-O, manufacturer: 3M
1. Power off the operator terminal.
2. Follow the instructions under
to remove the rear cover.
3. Flip the back cover (the CPU board and the battery are mounted on the rear side
of the back cover).
CPU board with battery holder on the rear side of the back cover
4. If the battery is glued with melting glue, remove the glue before carefully remov-
ing the battery from the battery holder.
5. Carefully fit the new battery into the battery holder. Make sure the plus sign on
the battery is set towards the plus sign on the holder.
6. Glue the battery to the battery holder with melting glue.
7. Re-assemble the operator terminal in reverse order.
Note:
Make sure you have adequate ESD protection.
Note:
Make sure to make a backup copy of the operator terminal project. See the
section.
Note:
The removed lithium battery should be recycled.
battery holder
