3-11
Operation
Action
Result
3. Press [
SHOW SET
].
The number you selected will appear in the program display. Run
parameters for that program will be displayed for 5 seconds. (To
make changes, see Changing a Program, below.)
4. Press [
ENTER
] and [
START
] to
begin the programmed run
(or press [
PROGRAM
] to exit
program mode and return to
manual operation).
The run starts, the green light next to the [
START
] key flashes, and the
rotor begins to spin.
➠
NOTE
To begin a run, [
ENTER
] must always be the last
key pressed before pressing [
START
]. If you wait
more than 5 seconds, the [
START
] key will not
activate. If this happens, press [
ENTER
] and
[
START
] again to begin the run.
If an unacceptable value was entered, the run will not begin when
[
ENTER
] and [
START
] are pressed. Check each display and make any
necessary corrections or additions. Press [
ENTER
] and [
START
] again to
begin the run.
The run will end automatically when the time display counts down to
zero. (Press [
STOP
] to terminate a run at any time.) The green light
next to the [
STOP
] key will flash while the rotor decelerates. A tone
will sound when the rotor has come to a complete stop.
5. After the rotor has stopped,
press [
DOOR
].
The door is unlocked.
6. Remove the rotor. Keep
the chamber door closed
between runs.
RECALLING AND CHANGING A PROGRAM
Recalling a Program
A program that has been saved in memory can be recalled at
any time.
