Beckhoff EJ6910, Operation Manual

Page: 62 / 110

Operation
EJ6910 62 Version: 1.7.0
4.3.7.10 Project settings - Verification
The project settings can be found below the target system.
Safe Address Verification
The Safe Address Verification entry is used to set how the safety addresses are checked.
• Project wide unique (recommended) - Unique safety addresses within the entire solution
• Similar to TwinCAT 2 - Unique addresses per TwinSAFE Logic
• Allow multiple usage - Multiple safety addresses are possible (Validation by the user necessary)
Fig. 80: Safe Address Verification
FB InPort Activation Verification
The FB InPort Activation Verification entry is used to determine how the input ports of TwinSAFE FBs are
checked.
• Strict activated & connected (recommended) - Each enabled port must be connected and each
connected port must be enabled.
• Activated or connected allowed - If a port is only activated or only connected, this does not lead to an
error message.
Fig. 81: FB InPort Activation Verification
4.3.7.11 Displaying the project size
Diagnostic Properties of the project node
If the project node of the TwinSAFE project is selected, the properties under the entry Diagnostic show the
current project parameters. These are e.g. the project size in bytes, the number of connections, the number
of function blocks, or the number of TwinSAFE groups.